EN-48869 Front Crankshaft Seal Installer

SKU# EN-48869

California Residents: Warning

Be the first to review this product

Reward Points You will earn 1 dollar off your next purchase for purchasing this product.

Item Condition: new

Ships today! Order now and receive by Friday March 29 when selecting UPS Next Day Air

In Stock!

Only 1 left

$111.43
Not sure if this is what you need? Give us a call and we'll look it up for free if you purchase the tools or parts from us!

EN-48869 Front Crankshaft Seal Installer

Applications: 60 Degree V6 (3.1L, 3.4L, 3.5L, 3.9L)

Current SI lists J-35468, but the pilot OD is approximately 3mm too large, and damages the seal. EN-48869 can be used to install the front seal with the engine in-vehicle or out. EN-48869 includes a threaded rod, nut, and thrust bearing to allow service in-vehicle, but is thick enough on the end to allow the seal to be driven into the bore with a dead-blow mallet. Other methods will damage the seal, resulting in premature seal failure.

Manufacturer SPX/Bosch (OTC Rotunda Kent-Moore Miller)
Brand SPX/Bosch (OTC Rotunda Kent-Moore Miller)
Storage Code F-14

Warning: This product can expose you to chemicals including lead, which are known to the State of California to cause cancer and birth defects or other reproductive harm.

For more information go to www.P65Warnings.ca.gov.